: "New Age" <new_age@freemail.hu>
: <mt13x9@yahoogroups.com>
: Re: [mt13x9] Re: New MTK MPEG Card
: 28  2008 . 13:54

Hello!

1) try entering setup and then press '0' after that rs232 may work

2) just uploaded my latest mt1389 flasher tool that supports serial flash read/write (at least it works with 89L having AMIC serial flash)

if (1) is not working there is another way (for my 89L with AMIC A25L80P it worked):

- unplug player from 230V
- connect serial flash "Chip Select" and "Ground" pins (usually pin 1 and pin 4) 
- plug player into 230V
- wait around 5 sec
- disconnect serial flash pins
- start flasher read/write

Keep in mind that serial flash reading is extremely slow (30minutes for 1MB).
Also this method only worked with one 89L player with that serial flash. Maybe it wont work.

First make sure your cables is 100% OK (reading/writing works OK) on a different player with parallel flash.

regards,

NA


From: avinash1626 
Sent: Wednesday, May 28, 2008 7:37 AM
To: mt13x9@yahoogroups.com 
Subject: [mt13x9] Re: New MTK MPEG Card


Thanks For Reply....
1) Which kind of keycombination is setup menu 
can i use to enable RS232 port.

2) Give some KeyCombination that you have tryed it.

3) If possible send me latest mtktool for this kind of eprom (EN25F80)
Thanks again....
Reply it soon..



 

<b>
 